Canon DADF-R1, Руководство по обслуживанию

Страница: 47 / 222

Chapter 2
2-21
4) Open the manual feed tray [1], and set A4 or LTR
paper [2] in it.
But the paper [1] against the rear side [3] of the
manual feed tray.
F-2-72
F-2-73
5) Press the push switch (SW2) on the DADF
controller PCB once.
-> In response, the original will be picked up and
stopped on the copyboard glass.
F-2-74
6) Open the DADF, and check to see that C in the
figure is as indicated.
T-2-3
F-2-75
7) Close the DADF, and press the push switch (SW2)
on the DADF controller PCB once.
-> In response, the original will be discharged to
the delivery tray.
8) When done, tighten the manual feeder tray fixing
screw.
9) Put the DIP switch (SW1) on the DADF controller
PCB back to its initial configuration, and attach
the DADF controller cover.
< If Not as Indicated >
If the dimension is not as indicated, adjust the
position of the manual feeder tray.
1) Loosen the manual feeder tray fixing screw [1],
and adjust the manual feeder tray [2].
- If C > 3.1 mm, move the manual feeder tray
toward the rear.
- If C < 3.1 mm, move the manual feeder tray
toward the front.
[1]
[2]
[3]
J1
J2
J5
J3
J6 J7 J8 J9 J10
J16 J15
J11
J14
IC8
J13
J12
J4
CB1
SW1
DSP1
SW4SW3SW2
Value of C
3.1+/-1mm
C
Original