Canon DADF-R1, Руководство по обслуживанию

Страница: 119 / 222

Chapter 3
3-61
3.7.3 Alarm Code
0013-3522
T-3-14
0079 belt status fault PI1 At time of a switchover of the belt motor state (acceleration, constant,
deceleration), the motor is not in any of the 3 states.
0080 image lead edge output
timing
fault S2, S3,
SW301 At time of stream reading, the image lead edge signal is generated
during acceleration over the distance from standby position to image
lead edge position.
0081 reversal speed setting fault PI5 The speed setting of the reversal motor is the minimum speed (100
mm/sec) or lower or is the maximum speed (700 mm/sec) or higher.
0082 reversal speed switchover
fault PI5 At time of a reversal motor speed switchover, the motor is not
operating at a specific speed.
0083 reversal status fault PI5 At time of a switchover of the motor state (acceleration, constant,
deceleration), the motor is not in any of the 3 settings.
0084 last original error PI1 While the last original is being discharged from the platen roller or is
being moved, a belt motor error has occurred.
0085 error PI1, PI2,
PI11 A motor error other than an IPC communication/pickup error has
occurred. (less than 3 occurrences)
0090 ADF open PI10 An ADF open condition has been detected.
0091 user DF open PI10 An ADF open condition has been detected while the machine is in
operation.
0092 cover open PI3, PI6 A cover open condition (front or rear) has been detected.
0093 user cover open PI3, PI6 While the machine is operating, a sensor in the paper path has
detected an original.
0094 initial stationary PI4, PI12,
PI13, S1, S2,
S3, S4, S5,
S9 At the start of operation, the presence of an original has been detected
by a senser in the paper path.
0095 cycle NG S6 While no sensor is on, the pickup signal is received for a specific time
(2 sec).
0096 residual original S1 Before the start of a left pickup job, the reversal sensor has detected
an original while the belt motor is being driven for a specific time.
0097 manual feeder residual
original S1, S9 At time of manual feed pickup, the reversal sensor detects an original
while the manual feeder registration roller sensor also detects an
original.
0098 power-down - While the machine is operating, a drop has occurred in the voltage of
the power supplied by the host machine.
Code Name Description
03 separation fault a jam caused by the 1st original not reaching the post-
separation sensor a jam caused by the 1st original not
reaching the registration sensor
11 decrease in number of
originals after jam
recovery a condition caused by a decrease in the number of originals
in the tray before delivery of as many as [originals to be
recovered - 1] have been delivered at time of jam recovery
21 mode fault selection of mode not permitting execution
Code Sensor type Sensor
notation Description