Canon DADF-R1, Руководство по обслуживанию

Страница: 46 / 222

Chapter 2
2-20
6) Open the DADF, and check to make sure that C is
as indicated.
T-2-2
F-2-68
7) Close the DADF, and push the push switch (SW2)
on the DADF controller PCB once.
-> In response, the original will be discharged to
the delivery tray.
8) When done, tighten the original tray fixing screw.
9) Put the DIP switch (SW1) of the ADF controller
PCB back to its initial configuration, and mount
the ADF controller cover.
< If Not as Indicated >
If the dimension is not as indicated, adjust the
position of the original tray.
1) Loosen the tray fixing screw [1], and adjust the
position of the original tray [2].
- If C > 3.1 mm for A4/11.9 for LTR, move the
original tray toward the rear.
- If C < 3.1 mm for A4/11.9 for LTR, move the
original tray toward the front.
F-2-69
2) When done, tighten the original tray fixing screw.
3) Put the DIP switch (SW1) of the ADF controller
PCB back to its initial configuration, and mount
the ADF controller cover.
B. Pickup from the Manual Feeder Tray
1) Remove the DADF controller cover [1].
- 1 screw [2]
F-2-70
2) Set the DIP switch (SW1) of the DADF controller
PCB as shown.
F-2-71
3) Turn OFF the power.
Original size Value of C
A4 3.1+/-1mm
LTR 11.9+/-1mm
C
Original
[1]
[2]
[1]
[2]
[1]