Canon DADF-G1, Руководство по обслуживанию

Страница: 130 / 154

COPYRIGHT© 2000 CANON INC. CANON DADF-G1 REV.0 OCT. 2000
CHAPTER 5 TROUBLESHOOTING
5-21
2.1.3 E402 Indicator
Belt motor clock sensor (S10)
1) Set the meter to the 200 VDC range, and connect the + probe to J9-
B4 on the DADF controller PCB and the - probe to J9-B3. Turn the
clock disc slowly by hand. Does the reading alternate between 5 and
0 V?
NO: Check the wiring from the belt motor clock sensor circuit (S10) to
the DADF controller PCB; if normal, replace the belt motor clock
sensor (S10).
Belt motor (M3)
2) Set the meter to the 200 VDC range, and connect the + probe to J7-
1 and the - probe to J7-2 of the DADF controller PCB. Does the
reading of the meter change to 23 V in response to a press on the
Start key?
YES: Check the wiring from the belt motor (M3) to the DADF controller
PCB; if normal, replace the belt motor (M3).
NO: Replace the DADF controller PCB.
2.1.4 E403 Indicator
Feed motor clock sensor (S9)
1) Set the meter to the 20 VDC range, and connect the + probe to J9-
A11 and the - probe to J9-A10 of the DADF controller PCB. Turn
the clock disc slowly by hand. Does the reading alternate between 5
and 0 V?
NO: Check the wiring from the feeding motor clock sensor (S9) to the
DADF controller PCB; if normal, replace the feed motor clock sen-
sor (S9).
Feed motor (M2)
2) Set the meter to the 200 VDC range, and connect the + probe to
J11-1 of the DADF controller PCB and the - probe to J11-2. Does
the reading change to 23 V in response to a press on the Start key?
YES: Check the wiring from the feed motor (M2) to the DADF control-
ler PCB; if normal, replace the feed motor (M2).
NO: Replace the DADF controller PCB.