![background image](http://html.mh-extra.com/html/canon/cr-180/cr-180_instructions-manual_62842022.webp)
Chapter 2
Preparation Before Use
18
◆
Connecting the SCSI Cable
Connect your computer to the scanner using the SCSI cable.
When only the scanner is connected to your computer, or when another SCSI
device is connected on a daisy chain, make sure that the scanner is the last SCSI
device at the end of the daisy chain. Also, turn all terminator SCSI devices that
are connected on the daisy chain between the computer and CR-180 to OFF.
Terminator OFF
CR-180
■
Before you connect the SCSI cable, make sure that the scanner and the computer
are turned OFF.
■
Do not connect both SCSI and USB interface cables at the same time.
SCSI Connector
USB Connector
(cannot be connected at the same time)
◆
Setting the SCSI ID
Set the SCSI ID using the DIP (Dual Inline Package) switch located on the left
side of the SCSI connector.
Push the DIP switches down to turn them ON, and push them up to turn them
OFF. Refer to the following table to set the SCSI ID using the DIP switches.
DIP Switches
The SCSI ID default is set to 2. Be careful not to set the same SCSI ID as other SCSI
devices that are mounted internally or connected to the computer.
CAUTION
Important
Содержание CR-180
