Cannon FITZP, Инструкция пользователя

Страница: 15 / 24

10
1. This appliance is to be installed by a licensed service person
only.
2. This appliance is to be installed in accordance with the
manufacturer’s installation instructions, AS 5601/AG 601,
Municipal Building Codes, Electrical Wiring Regulations and
any other statutory regulations.
3. Ensure the minimum clearances to combustible construction are
maintained during installation, including adequate space for
the proper operation and servicing of the heater.
For clearances to curtains and furnishing refer to warning 3 on
page 4.
For minimum clearances refer fig 9 and 10.
4. Remove the carton from the heater and lift from pallet.
Check that the heater is suitable for the gas available
(Please dispose of packaging appropriately, keep away from
children).
5. Prepare electrical and gas connections, a 10 Amp wall socket
needs to be located within 1.5m of the heater.
6. Fit rear spacers as per figure 10.
7. Place heater in position. (Check flue and gas connection posi-
tions. Refer to gas connection instructions on page 12 and flue
installation instructions on pages 14 & 15).
8. Remove the pedestal front by unscrewing two screws either
side. Refer figure 11.
10
Installation Instructions
9
Clearances
Installation
15
27. Switch burners off and remove the manometer tube. Tighten
pressure test point by turning the captive screw fully clockwise.
Replace plastic cap. Ensure the little lug is positioned towards
lower right hand side to clear the control.
28. Refit the lower front cover, making sure not to damage the
power cord.
29. Follow User Instructions to turn on heater.
I mportant:
To achieve the correct visual flame effect:
On Propane the gas pressure must be set at 2.65 kPa with burner
operating on maximum setting.
On Natural Gas the gas pressure must be set at 1.0 kPa.
25