Candela VelaShape, Инструкция по эксплуатации, Страница: 43 / 60

Copyright 2020 Product Guide. All Rights Reseved
Move to the next zone and treat similarly until reaching the endpoint (~5 minutes).
Come back to the first zone and treat again until reaching the endpoint (5 minutes
or less).
Treat the second zone again until endpoint (5 minutes or less).
If an optimal endpoint is not achieved, decrease the treatment area.
►
NOTE
• Good contact is essential for good results. Always maintain complete
contact between the applicator chamber and the skin.
• For small zones such as the navel area, treat twice, but with less
stacks until the endpoint is reached, and ensure a 5-minute interval
between treatments.
• When reinforcing results following Vsmooth, treat the small area
(such as localized fat deposits) only once.
• After the treatment, the treated area may show temporary signs of
erythema and slight edema.
• Blinking of the IR and/or RF LEDs on the operator panel indicates
inadequate coupling which results in RF and IR being disabled.
∆
CAUTION
Release the trigger before you lift the applicator from the skin.
Treatment Protocols
• Ideally, the treatment should be performed once a week. Spacing the treatments less than
once a week apart may reduce treatment efficacy. Usually 4-6 treatments result in significant
circumference reduction and cellulite improvement. Some patients may need a few more
sessions. Once per week is an acceptable protocol also when combining the Vsmooth and the
Vcontour applicators.
• One maintenance treatment in the month following the initial series of VelaShape II treatments
may be necessary to sustain the results, followed by once in 2 – 3 months according to
individual results.
►
NOTE
• Compliance with the treatment protocol is essential to achieving the desired
results.
• VelaShape II treatment performed 3–5 weeks post-liposuction can enhance
smooth recovery from the liposuction treatment.