Candela VelaShape, Инструкция по эксплуатации, Страница: 42 / 60

Copyright 2020 Product Guide. All Rights Reseved
3. Retain the heat by passing over both previous strips in cross-hatched motions
(zig-zag or circles).
4. Move to an adjacent strip and treat with back and forth motions until endpoint
5. Retain the heat again on all previous strips with cross-hatched motions.
6. Continue the process until you have covered the entire area.
• After the endpoint is achieved the patient may feel an internal heat sensation for
30 minutes or longer.
• Continue treatment with the Enhanced Treatment Mode which consists of two
steps:
Step 1: Reach the endpoint in a certain anatomical area (using the motions
described above).
Step 2: Return to the same anatomical area after ~10 minutes and repeat
the procedure reaching the endpoint again.
While waiting you may treat another area.
Retaining the heat by covering the treated areas in the interval is
recommended.
• When using the Vcontour applicator:
Divide the treatment area into smaller zones of roughly the size of the palm
of a large hand (10 x 15 cm; 4 x 6 inches).
Go over one zone to complete one pass by stacking with an overlap of
a~20%. The number of stacks applied should be according to patient
tolerance, but no more than 10 stacks.
Repeat the same procedure on the same zone, until the desired endpoint is
reached (~5 minutes). The number of passes is typically 4-6. Reduce the
number of stacks with each successive pass.