Candela VelaShape, Инструкция по эксплуатации, Страница: 30 / 60

Automatic Vacuum and RF Test
The VelaShape II is equipped with an automatic Vacuum and RF self-test routine.
The test is performed:
• Immediately after the system powers up
• 90 seconds after each release of the applicator's trigger
During the test the VelaShape II is tested for radiofrequency and vacuum performance,
displaying the status of applicator filters. During this test, the triggers of both applicators are
disabled.
The test is comprised of three consecutive vacuum pulses for each applicator connected to the
system, and can take up to 10 seconds.
It is important to verify that the applicators' chambers are not blocked or positioned against a
sealing surface during the test (i.e., verify that the applicator is not applied to the patient during
the test).
The test results will be displayed in one of the following manners. If a fault situation is displayed
refer to Chapter 8 – Troubleshooting
1. RF failure:
– RF LEDs column is blinking.
– 100 - RF Failure message on the communication terminal's display.
2. Vacuum sensor fault:
– 0 level LED of IR and RF columns are blinking – (Vsmooth applicator only).
– 101 - No Vacuum Sensor in LA/SA message on the communication terminal's display.
3. Filters are clogged or applicator chamber is sealed (against the patient's skin or other
surface):
– Vacuum LEDs are cyclically ascending from 1 to 3.
– 03 - Replace Filters message on the communication terminal's display.
4. Filters are missing, punctured or improperly inserted:
– Vacuum LEDs are cyclically descending from 3 to 1.
– 02 - Insert Filters message on the communication terminal's display.
If one of the above indications appears and you wish to repeat the test, press the trigger on any
applicator and wait for 90 seconds; the test will repeat itself.
Copyright 2020 Product Guide. All Rights Reseved