Candela GentleYAG, Руководство оператора

Страница: 96 / 160

GentleYAG Laser System Candela Corporation
8501-00-1766 Revision F CONFIDENTIAL Page 96
To clean or replace the HP Slider window: (figure 6.3)
1. Wear dustless gloves to prevent smudges or fingerprints on lens.
2. Turn the laser OFF. Remove the Distance Gauge. Slide the HP Slider through
the front of the HP; exposing the slider window or remove the HP Slider entirely
from the rear of the HP assembly. The window is held in a groove in the front
end of the Handpiece Slider with an O-ring. A notched access in the groove
allows easy removal of the O-ring and window.
3. With handpiece pointing upward, remove o-ring with tweezers, or poke a
pointed object into the notch. Gently pull the O-ring toward the center of the
window to free the O-ring from the groove. Then turn the handpiece slider
upside down, allowing the window to fall out onto a clean surface. (If needed,
gently tap the side of the handpiece slider with your finger).
4. (Used windows only)
c.
Clean the windows in an alcohol solution. Rinse thoroughly with clean
water, and dry with a lint free tissue.
d. Re-inspect the window and if unacceptable, discard window and replace
with a new one.
5. Grasp the new or cleaned window by the edges and place it back into the
handpiece slider so it is resting flat on the ledge.
6. Reinsert the O-ring into the groove. Use the tip of the tweezers or a pointed
object to gently push the O-ring fully into the groove, being careful not to touch
the window.
7. Slide the HP Slider back into the HP. Select a spot size. Then perform a
Calibration Procedure per section 5.