Can-Am DS 450 2008, Руководство по ремонту

Страница: 131 / 401

Section 03 ENGINE
Subsection 07 (CYLINDER HEAD/CYLINDER)
vmr2008-015-053_a
1. Circlip installer handle
2. Circlip installer sleeve
3. Piston
NOTE: Take care that the hook of the piston circlip
is positioned properly.
vmr2008-016-054
CORRECT POSITION OF THE PISTON CIRCLIP
PISTON RINGS
Piston Rings Removal
Remove:
– Cylinder head
– Piston.
Piston Rings Inspection
Using a feeler gauge measure each ring/piston
groove clearance. If the clearance is too large, the
piston and the piston rings should be replaced.
vmr2008-016-055_a
1. Piston
2. Feeler gauge
RING/PISTON GROOVE CLEARANCE
UPPER COMPRESSION RING
NEW
0.025 to 0.070 mm
(.0010 to .0028 in)
SERVICE LIMIT 0.120 mm (.0047 in)
LOWER COMPRESSION RING
NEW
0.025 to 0.070 mm
(.0010 to .0028 in)
SERVICE LIMIT 0.120 mm (.0047 in)
OIL SCRAPER RING
NEW
0.015 to 0.060 mm
(.0006 to .0024 in)
SERVICE LIMIT 0.100 mm (.0039 in)
Measure ring end gap.
RING END GAP
UPPER COMPRESSION RING
NEW
0.15 to 0.40 mm
(.0059 to .0157 in)
SERVICE LIMIT 1.00 mm (.0394 in)
LOWER COMPRESSION RING
NEW
0.15 to 0.40 mm
(.0059 to .0157 in)
SERVICE LIMIT 1.00 mm (.0394 in)
OIL SCRAPER RING
NEW
0.15 to 0.35 mm
(.0059 to .0138 in)
SERVICE LIMIT
1.00 mm (.0394 in)
To measure the ring end gap place the ring in the
cylinder in the area of 8 to 16 mm (.315 to .630 in)
from top of cylinder.
NOTE: In order to correctly position the ring in the
cylinder, use piston as a pusher.
Using a feeler gauge, check ring end gap. Replace
ring if gap exceeds above described specified tol-
erance.
Piston Rings Installation
Using fingers only, install the oil scraper ring first
with marking “O“ on top.
NOTE: First install spring and then the ring of oil
scraper ring.
vmr2008-015
111