Can-Am DS 450 2008, Руководство по ремонту

Страница: 15 / 401

INTRODUCTION
Spray Loctite Primer N on both mating surfaces
and on both sides of gasket. Allow to dry 1 or 2
minutes.
Apply Loctite 518 (P/N 293 800 038) on both sides
of gasket, using a clean applicator.
Place gasket on mating surfaces and assemble im-
mediately.
NOTE: If the cover is bolted to blind holes (above),
apply proper strength Loctite on the threads of
hole. Tighten.
If holes are sunken, apply proper strength Loctite
on bolt threads.
Tighten as usual.
Mounting on Shaft
Mounting with a Press
A00A3UA
1
2
3
1. Bearing
2. Proper strength Loctite
3. Shaft
Clean shaft external part and element internal part.
Apply a strip of proper strength Loctite on shaft
circumference at insert or engagement point.
NOTE: Retaining compound is always forced out
when applied on shaft.
DO NOT use antiseize Loctite or any similar prod-
uct.
No curing period is required.
Mounting in Tandem
Apply retaining compound on internal element
bore.
Continue to assemble as shown above.
Case-In Components
Metallic Gaskets
A00A3VA
1
1. Proper strength Loctite
Clean inner housing diameter and outer gasket di-
ameter.
Spray housing and gasket with Loctite Primer N
(P/N 293 800 041).
Apply a strip of proper strength Loctite on leading
edge of outer metallic gasket diameter.
NOTE: Any Loctite product can be used here. A
low strength liquid is recommended as normal
strength and gap are required.
Install according to standard procedure.
Wipe off surplus.
Allow it to cure for 30 minutes.
NOTE: Normally used on worn-out housings to
prevent leaking or sliding.
It is generally not necessary to remove gasket
compound applied on outer gasket diameter.
vmr2008-002
XIII