Can-Am DS 450 2008, Руководство по ремонту

Страница: 285 / 401

Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS)
Repair or replace wiring as required.
NOTE: When reconnecting the LED connectors,
be sure to connect the RED/VIOLET wire to the
positive (+) LED terminal or it will not function as
it will be in reverse polarity.
Neutral Indicator Light Removal
Remove dashboard, refer to
BODY
section.
Disconnect the wires from the indicator light.
Press both tabs then push indicator light out of the
dashboard.
1
V02A0FA
1
1. Tabs
Neutral Indicator Light Installation
For the installation, reverse the removal proce-
dure.
NOTE: The LED is subject to polarity. Make sure
to reconnect the RED/VIOLET wire to the positive
(+) terminal.
CHECK ENGINE INDICATOR
LIGHT (YELLOW)
Check Engine Indicator Light Operation
The check engine indicator light is an LED that will
come on flashing (momentarily) when the power
is first applied to the vehicle (light test function).
It is mounted in a cluster (dashboard) just ahead
of the fuel cap.
vmo2008-011-028_b
1. Neutral (N) indicator light
2. Check engine indicator light
3. Low fuel level indicator light
The light receives power from the cooling fan and
accessories fuse. When power is first turned on,
or when the ECM detects an engine related fault,
it supplies a ground to the light to advise you of an
abnormal engine condition.
Refer to the
MONITORING SYSTEM/FAULT
CODES
section for more information on the light
function.
Check Engine Indicator Light Testing
If the check engine indicator light does not come
on, carry out the following procedures.
Remove the dashboard, refer to the
BODY
sec-
tion.
Disconnect the check engine indicator light con-
nectors.
vmr2008-027-003_b
Test the LED as per the
NEUTRAL INDICATOR
LIGHT
procedure.
vmr2008-027
265