Can-Am DS 450 2008, Руководство по ремонту

Страница: 261 / 401

Section 06 ELECTRICAL SYSTEM
Subsection 02 (CHARGING SYSTEM)
Select the Monitoring tab.
On Monitoring page 1 , read the 12 Vdc system
voltage on the Battery Voltage meter and the en-
gine RPM on the Engine Speed indicator as per
following table.
CHARGING SYSTEM VOLTAGE TEST
WITH B.U.D.S.
TEST ENGINE SPEED VOLTAGE
4000 RPM 14.2 - 15.2 Vdc
vmr2008-138-010_a
TYPICAL
1. Voltage indication
2. RPM indication
If voltage is above specification, replace voltage
regulator/rectifier.
If voltage is below specification, test the follow-
ing:
– Battery ground wire continuity
– Voltage regulator/rectifier ground wire continu-
ity
– Battery cable from voltage regulator to battery
– Magneto stator (refer to
MAGNETO/STARTER
section)
– Wiring and connectors from stator to voltage
regulator.
Repair or replace as required.
Install all removed parts and connectors.
Voltage Test With a Multimeter
Proceed as follows:
Remove seat.
Measure battery voltage at the battery terminals.
vmr2008-025-002_a
BATTERY VOLTAGE TEST
Start the engine.
Install a digital/inductive tachometer (P/N 529 014
500) or equivalent to measure engine speed. Fol-
low manufacturers instructions.
NOTE: Vehicle RPM may also be read on the Mon-
itoring page of the latest applicable B.U.D.S. soft-
ware.
vmr2008-025-003_a
1. Battery
2. Multimeter
3. Digital tachometer
Measure charging system voltage at the battery
terminals using the Fluke 111 multimeter (P/N 529
035 868) as follows.
CHARGING SYSTEM VOLTAGE TEST
WITH MULTIMETER
TEST ENGINE SPEED VOLTAGE
4000 RPM 14.4 - 15.2 Vdc
If voltage is above specification, replace voltage
regulator/rectifier.
If voltage is below specification, refer to
VOLTAGE
TEST WITH B.U.D.S.
for sequence of tests to be
carried out.
vmr2008-025
241