10
12.Position steering limiter cable assembly under
anchor bracket and slide it over bolt (
A4
) already
inserted. Use washer (
C6
) and nut (
C7
) to secure
assembly to anchor bracket. Tighten nut to 50 N•m
[37 lb•ft]. Refer to Fig. 23
NOTE: Make sure arrow on top of aluminum disk
points towards front of vehicle.
Fig. 23
IMPORTANT
13.Make sure aluminum disk pivot point is installed in
front of steering limiter cable. See Fig. 24
Fig. 24
STEERING LIMITER ADJUSTMENT
WARNING: Before going to the next steps,
make sure that stabilizing arms are correctly
installed, and that the angle of attack and
alignment are correct. Refer to the
User
Manual
supplied at purchase.
14.Turn the vehicle’s steering wheel to its maximum
point of travel on the left. While maintaining
pressure on the steering wheel, turn threaded rod to
adjust length of cable. See Fig. 25
15.Position cable end hole
(1),
19 mm [
¾
in. ] short of
the support plate
(2)
WARNING: To prevent potential damage to
vehicle components, the
** ¾ inch [19 mm] **
gap is mandatory.
Fig. 25
16.Reverse steering wheel a little to be able to bolt
support plate and cable together. Tighten provided
bolt
(C4)
to 35 N•m [24 lb•ft]. See Fig. 26. Repeat
steps on right side.
Fig. 26
