8
FRONT TRACK SYSTEM
INSTALLATION
1. Remove front wheels. Make sure that wheel studs
and wheel hubs are free of dirt.
2. If applicable, remove CV joint protectors.
3. Remove bolts, nuts, washers and bushings from
front stabilizing rod ends as shown in Fig. 13
Fig. 13
4. Insert bolts in front anchor brackets (
A1
) as shown
Fig. 14
CAUTION: Make sure bolts are inserted in the right
direction. See Fig. 15
Fig. 15
5. Position bottom part of anchor bracket assembly
(
A1
) under lower suspension arm. Position bracket
cover (
A2
) over suspension arm. Align holes and
insert the cover's tenon in the mortise cut in the
bottom part. Refer to Fig. 16
Fig. 16
6. From the top, insert M10x85mm bolt (
A4
) through
bracket cover and bottom part. Insert M10x50mm
bolt (
A3
) through the bottom and secure the two
parts together with nut (
A5
) provided. Tighten
assembly to 50 N•m [37 lb•ft] of torque. See Fig. 17
Fig. 17
7. Secure undercarriage to front hub using the
provided M10 lug nuts (
D
). Use bolt circle
Ø110
mm
.
CAUTION: If needed, take rubber protector off
of hub.
CAUTION: Follow torque specification indicated by
vehicle manufacturer when tightening wheel nuts.
