Campbell Hausfeld GN5060 Скачать руководство пользователя

Страница: 4 / 48

www.chpower.com

Operating Instructions and Parts Manual

Pre-Operation (Continued)

GROUNDING

1. Use the ground terminal and

wing nut on the generator frame
to connect the unit to a suitable
ground source. Securely fasten
the end terminal of the ground
wire to the ground terminal on
the generators frame. Tighten the
washer and wing nut on top of the
ground wire end terminal.

2. The ground wire should be made

of #8 gauge wire. Do not use wire
with a higher gauge number.
Higher gauge numbers indicate
thinner wire, which may not
provide an adequate ground path.

3. The other end of the ground wire

must be securely fastened to an
approved ground source.

The following are ground sources
approved by the National Electric
Code. Other ground sources may be
acceptable. Refer to the National
Electric Code and local regulations for
further ground source information. If
not sure of regulations or procedures,
obtain assistance from a qualified
(licensed or certified) electrical
technician.

a. An underground water pipe at

least ten feet in length

b. A non-corrosive underground

pipe at least eight feet in length
and 3/4 inch diameter

c. A steel or iron underground rod

at least eight feet in length and
5/8 inch diameter

d. A non-ferrous rod at least

eight feet in length, 1/2 inch
in diameter, and approved for
grounding purposes

Any rod or pipe used for grounding
must be driven to eight feet deep or
buried in the deepest possible trench.

FUELING AND REFUELING
(SEE FIGURE 1)

1. Shut-off engine and wait 2 minutes

before filling fuel tank.

2. Remove fuel cap and fill fuel tank

to bottom of metal filler neck;
about 1-3/8 inch [3.5 cm or 35 mm]
from top of filler neck opening.

3. Do not overfill fuel tank. Overfilling

may damage roll-over valve and
carbon canister.

4. Reinstall fuel cap; make sure to

rotate cap clockwise unit it stops.

STARTING

1. Remove all electrical loads from the

generators.

2. Rotate fuel petcock valve lever,

located on underside of fuel tank,
to the vertical position to open
valve.

3. Flip engine toggle switch (on

control panel) to the ON position.

4. The engine is equipped with an

automatic choke. However, the
choke mechanism has a manual
override feature for extreme cold
weather starting. For extreme cold
weather starting, pull choke wire;
after engine warms, push choke in
to it's normal operating position.

5. Pull the starter rope with a brisk,

smooth motion.

6. After each start up, allow the

engine to run for 2-3 minutes with
no load.

Engine speed is

preset to provide

proper output voltage. Never attempt
to modify or adjust engine speed or
output voltage.

ENGINE BREAK-IN

After initial start-up, the engine
should be broken in according to the
manufacturer's instructions. Refer to the
engine manual for the proper break-in
procedure.

SHUT-OFF

1. Shut off and remove all electrical

load devices from the generator.

2. Allow the engine to run for 2-3

minutes with no electrical loads.

3. Flip the engine toggle switch (on

control panel) to the OFF position.

4. Verify that the generator has

completely stopped.

5. Rotate fuel petcock valve lever,

located on underside of fuel tank,
to the horizontal position to close
valve.

6. Allow the unit to cool before