14
4)
If installing the sprockets without the plastic
support, install the individual or preassembled
sprockets and the spacers on the sprocket body of
the hub aligning the spline patterns (Fig. 28). The
profile of the freewheel body with two asymmetri-
cal grooves (Fig. 28) ensures automatic sprocket
timing since there is only one assembly option.
5)
Using a torque wrench (D - Fig. 29) equipped
with Campagnolo
®
tool UT-BB080 (B - Fig. 29),
tighten the lockring (G - Fig. 29), which is provi-
ded with the Campagnolo sprockets, on to the
freewheel body to
40 Nm (354 in.lbs)
.
4.2.2
- DISASSEMBLY
1)
Remove the lockring (G - Fig. 30) using the
Campagnolo
®
tool UT-BB080 (B - Fig. 30) with a 24
mm hexagonal wrench (E - Fig. 30) and the chain
whip Campagnolo
®
UT-CS060 (F - Fig. 30).
2)
Insert the plastic sprocket carrier on the side of
the freewheel body and align the spline patterns
on the body with those on the carrier. Slide the
sprockets onto the carrier.
3)
Slide the sprockets, off the freewheel body
(Fig. 31).
ENGLISH
C
B
D
UT -BB080
40 N.m - 29.5 lb.ft
40 Nm
(354 in.lbs)
CLOSE
G
D
B
28
29
UT-BB080
C
E
APRIRE
OPEN
ÖFFNEN
UT-CS060
B
UT-BB080
F
G
B
F
E
OPEN
30
31
UT-BB080
UT-CS060
