MW8 & MotionWare User Guide: Issue 1.2.1
Page 68
This sequence is critical to the correct watch operation
– if
the LED does not flash, remove the battery and repeat the
process.
The MotionWare software will automatically detect that a
new battery has been fitted and display a warning
message requesting confirmation. Select ‘Yes’ and the
software should display 100% in the battery life indication.
If the new battery is not detected it is possible to use the
‘new battery’ button in utilities. Note that there are two
levels of warning message. Do not use this option if a new
battery has NOT been fitted
– the watch may stop
prematurely with no warning and the battery life indicator
will be incorrect.
A6 - Waterproof Seal
The MotionWatch relies upon a rubber O-ring seal around
the top face of the lower part of the casing. The seal
should be periodically checked to ensure that it is correctly
seated, clean and not damaged. (note that some silicone
grease residue will be apparent
– do not remove this).
Periodically apply a small amount of silicone grease to
ensure the seal remains supple.
A7 - MotionWatch
Strap
The MotionWatch is supplied as standard with an extra-
long moulded silicone watch strap. The strap is fitted with
two standard 12-14mm watch spring bars. These bars are
spring loaded to allow fitting and removal from the watch
casing (see photo).
To remove the Strap:
Use a flat bladed tool to gently
depress one end of the spring bar by levering against the
side of the casing. Take care not to damage the
MotionWatch casing.
To Fit a Strap:
Push the spring bar into the hole through
the strap then place one end of the spring bar into one
hole in the watch casing. Gently depress the exposed end
of the spring bar and then slide into the hole in the casing;
a positive ‘click’ will be heard.
