Cameron NuFlo MC-II, Руководство пользователя

Страница: 16 / 47

MC-II Flow Analyzer
12
Bypass Security Password
Forget your password? With the MC-II, you can have your access restored
quickly and easily with a one-time bypass code.
Press RESET
simultaneously to display
the bYPASS menu.
TOTAL
RATE
Call 1-800-654-3760 to
request a one-time
security bypass code.
To obtain this bypass code, perform the following steps:
1. Press and hold
ACCESS
and
RESET
simultaneously for 3 seconds,
then release. The word “bYPASS” will appear in the upper display,
and a number will appear in the lower display.
2. Record this number (it will remain on the display panel only for a few
seconds).
3. Call a Cameron (Measurement Systems Division) representative, and
give him/her the number and the serial number of the MC-II. After
verifying your identity, he/she will provide you with a one-time by-
pass code.
4. Enter the bypass code in place of your password at the CodE
prompt.
Important—Prior to exiting the Calibration menu, the CodE menu is
displayed again, and zeroes will appear in the bottom display. Select a
password using the INCREMENT key, and press ENTER/STEP to save
your password.
To re-enter a numerical calibration setting before you have selected
and saved the last digit, press and hold RESET for 3 seconds, then
release. The right-most digit will resume blinking, allowing you to
enter the entire number again.
To retain a numerical calibration setting and advance to the next
menu without pressing ENTER/STEP repeatedly, press and hold
ACCESS for 3 seconds, then release. This shortcut applies only to
numerical fields. You must press ENTER/STEP to select all other
entries.
If the MC-II is left in the Calibrate mode for longer than 1 minute, it
will time-out and return to the Run mode. Data that has been saved
with the ENTER/STEP key will be saved. However, data that was
selected but not entered will be lost.
Data Entry Tips
000000