ENGLISH
Page
25
- Manual code:
FA00464-EN
ver
.
1
03/2017 © C
AME S.p.a. - The data and information shown in this manual ar
e t
o be consider
ed as subject t
o change at any time and without the need for any advance warning.
Addressing and learning peripherals
ACQUIRING KEYPADS
The system cannot have keypads with identical addresses
The control unit leaves the factory with keypad 1 enabled, which
corresponds to the local keypad
In order to connect a keypad on a Bus, given that they are all pro-
duced with the address 01, their address must be changed, making
it 02 or 03
The table below shows the steps to take for a new keypad to be
addressed and acquired by the control unit In the example Keypad
02 is being acquired
STEP 1: Assigning address to new keypad
1 The display of the keypad to be added to the system will show
NOT AVAILABLE
at switch-on;
2 Press and hold down button
(*)
of that keypad, until the
KEYPAD MENU
is displayed;
3 With the
(
▲
)
/
(
▼
)
buttons move to the
ADDRESS MENU
and press
(*)
;
4 With the
(
+
)
/
(
‒
)
buttons select
ADDRESS 02
, press
(*)
and
(#)
twice to exit, the keypad will display
WAIT...
*
▼
▲
▼
▲
*
*
#
#
NOT AVAILABLE
KEYPAD MENU
ADDRESS MENU
ADDRESS 02
WAIT...
STEP 2: Enabling keypad in control unit
1 From a keypad that has already been correctly acquired (usu-
ally keypad 1), go into the Technical Menu
2 With
(
▲
)
/
(
▼
)
select
SYSTEM
and press
(*)
3 With
(
▲
)
/
(
▼
)
select
MODIFY SYSTEM
and press
(*)
4 With
(
▲
)
/
(
▼
)
select
KEYPADS
5 With the number keys select the keypad to be enabled (
(#)
=
enabled,
(
‒
)
disabled), in our case press key
(2)
6 Press
(#)
to return to the
MODIFY SYSTEM
menu
*
▼
▲
▼
▲
▼
▲
*
#
2
SYSTEM 02
MODIFY
SYSTEM
MODIFY
SYSTEM
KEYPADS
#-
KEYPADS
##
ACQUIRING INSERTERS
The system cannot have readers with identical addresses
All the readers are produced with address 1 and the control units do
not have a reader enabled as a factory setting
The control unit sees the on-board keypad's reader as the reader of
the keypad itself, therefore the two readers that can be connected
by bus should have address 01 and/or 02
For a new reader to be addressed and acquired by the control unit
you must (example of adding reader 2):
STEP 1: Enabling readers in control unit
1 Go into the Technical Menu
2 With
(▲)
/
(▼)
select
SYSTEM
and press
(*)
3 With
(▲)
/
(▼)
select
MODIFY SYSTEM
and press
(*)
4 With
(▲)
/
(▼)
select
INSERTERS
5 Use the number keys to select the reader to be enabled (
#
=
enabled,
-
= disabled)
6 Press
(#)
to go back to the previous menu
*
*
SYSTEM 02
MODIFY
SYSTEM
▼
▲
▼
▲
INSERTERS
#-
▼
▲
INSERTERS
##
#
2
