FA01694M4A - 06/2022
FA01694M4A - 06/2022
Resetting procedure
☞
THE RESETTING procedure must be done on both the
receiver and the transmitter.
☞
If you replace any device on the system, you will have to
RESET and then again SAVE all of the system devices.
- Keep pressed the T2 button on for about 10 seconds on the
RIOPH8WS card, until the CH1 and CH2 LEDs fl ash red.
Batteries
⚠
Only replace with the same or equivalent battery type.
⚠
The batteries must be replaced by a specialized
assistance center and only by qualifi ed technicians.
⚠
Keep the batteries away from children's reach.
If swallowed, seek immediate medical attention.
⚠
The supplied battery’s life also depends on its storage
time. Fit the batteries when saving.
⚠
When the batteries are almost fl at on the RIOPH8WS
device, it makes a buzzing sound every 10 seconds.
Maintenance
Clean the photocells with a moist cloth; do not use any solvents.
Troubleshooting
See the chapter on: troubleshooting issues on the RIOCT8WS or
the RIOCN8WS control card.
Legislative references
This product complies with the applicable standards in force
at the time of manufacturing.
RED
- CAME S.p.A. declares that the product described in
this manual complies with Directive 2014/53/EU and the
Radio Equipment Regulations 2017.
The full EC declaration of conformity and UK Conformity
Assessed (UKCA) marking information can be found at www.
came.com.
DECOMMISSIONING AND DISPOSAL
. Dispose of the
packaging and the device at the end of its life cycle
responsibly, in compliance with the laws in force in
the country where the product is used. The recyclable
components are marked with a symbol and the material’s
ID marker.
THE DATA AND INFORMATION IN THIS MANUAL MAY
BE CHANGED AT ANY TIME AND WITHOUT NOTICE. The
measurements, unless otherwise stated, are in millimeters.
