FA01694M4A - 06/2022
FA01694M4A - 06/2022
Installing
⚠
Fit the RIOPH8WS photocells near the RIOCN8WS or
the RIOCT8WS card, so as not to have any metal or cement
obstructions.
- Fasten the RIO-LUX base
④
to the DB-L column (not
supplied), or to the wall.
- Fit the control card
⑧
into the base
④
and fasten with the
supplied screw
⑦
.
- Save, the RIOPH8WS transmitter and receivers, on the
RIOCT8WS or THE RIOCN8WS control card (SEE THE SAVING
CHAPTER).
- Make the necessary functional checks (see the manual FOR
the RIOCT8WS OR THE RIOCN8WS).
- Shut the casings by latching the top of the cover and fastening
it with the supplied screw
⑥
.
Saving
Fit the batteries into all accessories that will be saved.
⚠
After three minutes, the devices shift into stand-by
mode; to reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are fl ashing red
simultaneously, otherwise do a reset (see THE RESETTING
PROCEDURE).
SAVING T1
Press, for one second, the T1 button on the RIOPH8WS
card: the CH1 and CH2 LEDs will fl ash red in alternation.
Press, for one second, the PROG button on the RIOCN8WS
card or the RIOCT8WS card: the WIRELESS LEDs, on the
RIOCN8WS or the RIOCT8WS card, will switch to from
fl ashing to off , and the CH1 LED on the RIOPHWS card will
fl ash blue once and then switch off .
SAVING T2
Press, for one second, the T2 button on the
RIOPH8WS card: the CH1 and CH2 LEDs will fl ash red in
alternation. Press, for one second, the PROG button on the
RIOCN8WS card or the RIOCT8WS card: the WIRELESS
LEDs, on the RIOCN8WS or the RIOCT8WS card, will switch
to from fl ashing to off , and the CH1 LED on the RIOPHWS
card will fl ash blue once and then switch off .
⚠
To interrupt the SAVING procedure, press the RESET
BUTTON.
