Manuale Uniflam Idro rev. 00
25
When the combustion starts, you can adjust the flow of combustion air by adjusting the air intake
window of the ashtray and adjust the draft through the knob.
It is also possible to operate the valve to regulate the smoke in the chimney.
CAUTION: The gas valve for UNIFLAM series models has been designed in order with EN 13240 and
its subsequent updates, so it has a minimum of free cross section to ensure the safe discharge of
flue gases.
CAUTION: Do not forget to activate the switch (position ON)
It is considerable to optimize the combustion process, to avoid overloading of the combustion
chamber and at the same time to position the fuel load in a way not to go over the wood rack and
keep space between the wood and the door.
WARNING: Failure in following these rules, as well as an effective management of the product
could result in a malfunction or damage of the painting of the doors.
The heater has to work, except in the ignition phase and during load, with the door closed to
prevent the outflow of fumes.
Leaving the door open causes that too much air enters in the heater and the efficiency of
combustion will be influenced negatively. The chemical process of combustion would be disturbed
and therefore cause an increased consumption and overheat.
In particular it has to be underlined again, that during the first times of firing it is highly
considerable to keep a medium flame and ventilate the room well in order to evaporate the smells
caused by some paintings of the new materials.
CAUTION: It is absolutely not considered to burn treated wood (painted, lacquered, or other) or to
turn on the fire by using flammable liquids and / or detonating materials (petrol, kerosene, diesel,
alcohol, etc.).
