Step 1. Start Descaling Cycle
-
Turn the DIAL to the STEAM position.
-
The STEAM LIGHT will now be
fully illuminated.
-
The Pump will start and hot water will run
from the Group Head and Steam Wand.
Over a 2 minute period the Pump will
make different noises.
-
When hot water has stopped being
released from the Group Head and Steam
Wand, this step is finished.
-
To indicate the machine has finished this
step, the machine will beep, the STEAM
LIGHT will stop being illuminated and the
DIAL LIGHT will now start to flash.
-
Turn the DIAL to the vertical position.
-
The DIAL LIGHT will now be
fully illuminated.
-
Move to Step 2.
Step 2. Preparing for Purge
-
The Steam Wand and Group Head now
need to be purged clean with fresh water
to remove descaling solution.
• Rinse Water Reservoir
- Remove the Water Reservoir and
rinse thoroughly under running water,
ensuring that all traces of the descaling
solution have been removed.
• Fill Water Reservoir
-
Fill the Water Reservoir to the '1 Liter'
line with cold water from the tap and
insert into position.
• Empty Containers
-
Empty water from the containers
and replace.
-
Move to Step 3.
Step 3. Start Purge
-
Turn the DIAL to the STEAM position.
-
The STEAM LIGHT will now be
fully illuminated.
-
The Pump will start and hot water will run
from the Group Head and Steam Wand.
Over a 2 minute period the Pump will
make different noises.
-
When hot water has stopped being
released from the Group Head and Steam
Wand, the Descaling Cycle is complete.
Descaling Cycle Complete
-
To indicate the completion of the
Descaling Cycle the machine will beep
and the ON/OFF LIGHT will stop flashing.
-
The STEAM LIGHT will stop being
illuminated and the DIAL LIGHT will now
start to flash to prompt the return of the
DIAL to the vertical position.
-
Turn the DIAL to the vertical position.
-
The machine will return to the READY state.
Descaling Cycle Clean Up
-
Empty water from the containers and
clean, ensuring that all traces of the
descaling solution have been removed.
31
Descaling Cycle - Espresso Machine
Important:
There is a maximum of 5
minutes allowed to complete this step
before the Descaling Cycle will exit.
Important:
The Descaling Cycle can be
exited at any point by pressing the
ON/OFF BUTTON.
Note:
The ON/OFF LIGHT will continue
to flash until completion of the
Descaling Cycle.
Important:
If Descaling Step 1 is not
started within 1 minute of entering the
Descaling Cycle, the machine will exit
the Descaling Cycle and go back to the
READY state.