CONTROL BOX WIRING
CM9-2 INSTALL ATION AND OWNER MANUAL V.3.1 | 2023.06.01
PAGE 14
To ensure safe and proper installation, it is essential to follow these steps carefully and refer to the specific
model's user manual or manufacturer's guidelines. Here's a summarized version of the steps for connecting
the linear arm, photosensor, and power cable to the power box:
Step 1 - Connect the Linear Arm with the Power Box:
1. Unscrew the large water-resistant cable gland on the cable and insert into the pre-drilled hole located
1. on the bottom left of the power box. Hand-tighten until secure.
2. Follow the label on the wire and connect it to the circuit board as follows:
a. Motor Cable: Motor 1 (Red), Motor 2 (Black)
b. Physical Limit Cable: Common (Yellow), Common (Green), Limit 1 (Purple), Limit 2 (Grey)
c. Sound and Light Cable: MAGLOCK Port - DC24V (Orange), GND (Blue)
Step 2 - Connect the Photosensor with the Power Box:
1. Unscrew the large unused water-resistant cable gland (located on the bottom left of the power box).
2. Insert the Photosensor cable through the cable gland and hand-tighten it to secure.
3. Follow the label on the wire and connect it to the circuit board as follows:
a. Photosensor Cable: MON-CLOSE (Brown), COMMON (Blue/White), MON-24VDC (Grey)
NOTE: Some photocell sensors may have 3 or 4 wires
Before proceeding with the installation, make sure to read the entire installation manual provided by the
manufacturer, including any safety guidelines and precautions. It's also recommended to have a qualified
professional or technician handle the installation to ensure the gate opener system is correctly set up and
safe to use.
COMMON
COMMON
DC24V
GND
MOTOR 2
MOTOR 1
LIMIT 1
LIMIT 2
3 WIRES WIRING DIAGRAM
4 WIRES WIRING DIAGRAM
MON-CLOSE
COMMON
MON-24VDC
MON-CLOSE
COMMON
MON-24VDC
