CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
5 / 20 / 2021 / Rev 3
Page 8 of 11
ALS
500T-DBR-HC
INSTALLATION INSTRUCTIONS
Installing Ceiling Trim
Trim Retention Spring
Keep Trim Retention Springs
4” from this edge
4’
4’
4’
4’
16’
Cut Line
8’
2’
Trim Retention Spring
Ceiling Trim
4’
4’
4’
4’
16’
8’
2’
6’
Seams between trim and fixtures not aligned
Install Trim Retention Springs to ceiling trim. Use one clip per 2’, or two clips
per segment under 4’. Install clips 4” from each edge, evenly spaced.
3
Measure and cut a 2’ section from one of the Ceiling Trim segments.
2
Measure installation area to determine required lengths of Ceiling Trim.
Example:
16’ required two 8’ sections of Ceiling Trim.
1
Install Ceiling Trim with Trim Retention Springs to mounted luminaires.
Ensure all springs snap into channel and that trim is not loose or sagging.
Note:
Place trim pieces carefully, they can not be removed after installing.
Note:
Ensure placement Trim Retention Springs is at least 4” from edges of
luminaire where wiring is present.
4
