timestamps. If no NMEA messages are received, the ACU states a fault.
Antenna course --- The Antenna course is an additional offset which is included into the
azimuth calibration. It is used for mobile antennas to set the orientation of the antenna
without recalibrating it. For stationary antennas this value always should be set to 180??.
Antenna longitude --- The geodetic longitude of the antenna. For a precise orbit to
pointing calculation this value should be entered with 0.001?? accuracy.
Antenna latitude --- The geodetic latitude of the antenna. For a precise orbit to pointing
calculation this value should be entered with 0.001?? accuracy.
Antenna abs. altitude --- The absolute altitude over sea of the antenna location.
Orientation
Compasstype --- Applicable only for car-mobile variants of the ACU
Inclinometer type --- Applicable only for car-mobile variants of the ACU
Nick offset --- Applicable only for car-mobile variants of the ACU
Roll offset --- Applicable only for car-mobile variants of the ACU
SNMP Control
From Software version 2.1.007 or higher, the sat-nms ACU contains an SNMP agent listening at
UDP port 161. The SNMP agent provides a common subset of the MIB-II system / interface
parameters and gives full access to the remote control capabilities of the sat-nms ACU with a
number of MIB objects placed in the private.enterprises tree.
The actual MIB file defining the ACU's private MIB may be downloaded from the ACU itself by FTP
(user 'service', password 'service'). The file 'ACUODM.MIB' contains all necessary information.
SNMP read community --- Sets the SNMP community string expected for read access. The
default is 'public'.
SNMP write community --- Sets the SNMP community string expected for write access. The
default is 'public'.
SNMP trap community --- Sets the SNMP community string sent with traps. The default is
'public'.
SNMP traps --- This parameter decides if the SNMP traps are enabled or disabled.
SNMP system name --- The ACU replies to MIB-II sysName requests with the text entered at
this place.
SNMP system location --- The ACU replies to MIB-II sysLocation requests with the text
entered at this place
SNMP system contact --- The ACU replies to MIB-II sysContact requests with the text
entered at this place.
MIB File --- click here to download the MIB file
SNMP trap IP 1-4 --- Enter up to 4 trap destination IP addresses (dotted quad notation) to
make the ACU sending traps by UDP to these hosts. Setting the parameter to 0.0.0.0
disables the trap generation.
Access Control
User password --- Here you can define the password for the 'user' login. Default password
is 'user'. When you are logged in as 'user' you can command the antenna pointing, set the
tracking parameters (if applicable) and store / recall targets. You can't modify the setup
parameters or issue low level commands on the test page while logged in as 'user'.
Admin password --- Here you can define the password for the 'admin' login. Default
password is 'admin'. When you are logged in as "admin" you have full access to all
(C) 2022, SatService GmbH
www.satnms.com
ACU2-19V2-UM-2209 Page 41/99
