Calder Brothers Mauldin Precision Spray, Руководство владельца/оператора и каталог запасных частей

Страница: 33 / 87

I. Machine Operation:
ion selector switch, in the “Master Control” located at the rear of
d
. Off:
s are off.
a. Using a 8 posit
the unit, the operator can select between the following modes; “Off”, “Cab”,
“Clean out”, “Hand spray / Unload”, “Transfer”, “Load”, “Tank Circulate”, an
“Reverse Suction”.
b
All Function
c. Cab control:
oller will monitor ground speed. If the machine is moving the
itch to
The contr
Asphalt pump will be turned at the appropriate speed to keep the
application rate constant at all ground speeds.
(Use the Scroll sw
adjust the screen contrast here.)
Units: Flow=Gallons per Minute
re Yard
· Upon entering this mode or anytime the OFF/SPRAY switch is
ate
· When the OFF/SPRAY switch is momentarily clicked to SPRAY
· If the OFF/SPRAY switch is momentarily clicked to SPRAY a
e
· If a preset Distance was set the controller will put the bar into Bar-
ntil
Bar=FT/Inches
Rate=Gallons per Squa
momentarily clicked to OFF, the controller will be in Bar-Circul
mode pumping at 100 GPM.
the first time the controller will go to Spray-Standby Mode. This
will direct all pump flow to the bar, dead-heading the pump and
pressurizing the bar. Pump flow is reduced to 25 GPM to reduce
excess nozzle flow at the beginning of the spray.
second time the controller will go to Spray Mode. This opens th
Spray-Bars and sets the pump flow to maintain the set Application
Rate while monitoring Bar-Width and Ground-Speed.
Circulate Mode after the preset Distance has been traveled.
Otherwise, if the preset Distance=0 then the bar will Spray u
the OFF/SPRAY switch is momentarily clicked to the OFF
position.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page33
V2.2