Battery Tray
Bolts Here
9
78
100
101
102
103
4-40 x 1/8”
Set Screw
Bag 10
4-40 x 3/8”
Red Socket Cap
B
ODY
P
OSTS
1 - Secure the shorter front body posts [96] to the front bumper with
the steel button head screws [97].
2 - Mount the longer rear body posts [98] to the Tweak Plates, using
the red socket cap screw [78]. The tweak plates have two body
mount locations to accommodate numerous body sizes and styles.
Choose the hole that will work best with your body.
3 - Thread the 1/8” set screw [45] into the plastic collars [99]. Adjust
the collar up and down the body post to accommodate the body shell
used. Lock the collar with the set screw.
15
45
78
Adjust body height
by raising or
lowering this collar
99
98
45
97
96
M3 x 8mm Steel
Button Head
97
Two rear body
mount locations
Bag 11
4-40 x 3/8”
Red Socket Cap
3/16” Shim
3/16” x 5/16”
Flanged Bearing
78
Red Locknut
9
100
101
4-40 x 1/4”
Steel FH
102
1 - Use the 4-40 x 3/8” red cap head screws [78] to bolt the
rear wheels to the hubs.
2 - Insert the flanged bearings [101] into the front wheels.
Place a 3/16” shim [100] over the axle, then the front wheel,
& then a red locknut [9] last. The front wheels should spin
very free. Do not over-tighten the front wheel nuts so that the
bearings are pinched.
3 - Install the battery tray [103] using four 4-40 x 1/4” steel
FH screws [102].
(Tires not included)
(The tray for NiCd/NiMh batteries is shown in the
picture. Also included is a flat LiPo battery tray.)
