CRC
Tube
Lube
Bag 5
2-56 set-
screw stud
2-56 Plastic
Ball Cup
Short 4-40 Plastic
Ball Cup (on tree)
.035”
Allen Driver
Delrin Plunger
Aluminum Tube
.125 "
1
2
3
5
4
.188 "
1 - Use the small allen key [30] to drive the 2-56 set screw
stud [31] into the thin plastic ball cup [32].
2 - Leave about 3/16” (half the set screw length) protruding
from the ball cup.
3 - Do the same for the short 4-40 ballcup [33]. Use the 4-40
x 5/16” set screw [25] and the slighty larger .050” allen key.
Leave about 1/8” protruding.
4 - Thread the 2 ball cups into their respective tube halves
per the diagram. Finger tighten.
5 - Add CRC Tube Lube [34] to each slot on the delrin
plunger [35]. Build the tube and be sure it has smooth,
damped action. *** Note, fill only the slots, not the entire
aluminum tube [36]. ***
Damper Tube to Chassis assembly
Snap the assembled & lubed damper tubes on the
respective points as shown in the diagram to the right.
You will find it easier to snap on the centered, smaller
2-56 ball studs first, then pop the outer, larger 4-40
ballcups on.
Completed Tube
Damper Tubes
6
4-40 x 5/16”
set screw
25
30
31
32
30
31
32
25
33
33
34
36
35
36
35