Bag 6B
Graphite Shock
Mount Plates (x2)
Battery Top Deck
41
42
Aluminum Shock /
Antenna Mount
4-40 x 1/4”
Red Alum FH
23
Red Locknut
9
4-40 x ½”
Steel Cap Head
43
Brass Washer
44
1 - Assemble shock mount as shown by inserting two
steel 4-40 x ½”cap head screws [43] through a graphite
plate [41], then through the aluminum mount [42], and
through the other graphite plate. Secure the screws and
tighten the assembly with two red locknuts [9].
2 -
For now, slide the
third screw through one of the shock mount holes, slide
the washers over the screw, and lightly tighten with the
third locknut, just so we don’t lose the parts.
The ball shown in the picture is part of the center
shock, and we will get to this in bag 7.
8
4-40 x 1/8”
Set Screw
45
41
44
43
42
9
23
46
45
47
1 - Attach the completed center shock mount to the Top
Deck [46] using two 4-40 x 1/4” red FH screws [23] in the
holes shown in the diagram.
2 - Insert the antenna tube [47] into the center shock
mount and tighten with a 4-40 x 1/8” set screw [45].
The actual antenna tube in the kit is much longer
than what is shown in the picture.
NOTE -
0.5”
1.0”
2.5”
1 - Using either a hobby knife or scissors, cut the adhesive backed foam [48] into three
pieces according to the guide in the lower left corner of the page.
The guide is drawn to scale and you will be able to measure the foam by holding it
over the drawing.
2 - Peel the paper backing off the foam strips and stick them to the bottom side of the Top
Deck [46] as shown in the diagrams.
NOTE -
48
48
48
4-40 x 1/4”
Red Button Head
22
NOTE
- The ball
pictured here is not
included in this step.
