8600 Series
Installation Instruction
7 of 40
CAL-ROYAL PRODUCTS, INC.
6605 Flotilla St. Commerce CA 90040
Tel: (323) 888-6601; Fax: (323) 888-6699
Email: [email protected]; Website: www.calroyal.com
•
t
technicians are
•
all
is
to the
any
or
maintenance.
•
on any
or
parts.
•
the operator or
•
controls
the
the
strictly
is
the
the
installer
operator
A156.19 Standard for Power Assist and Low Energy Power
Operated Swing Doors, local
to complete the site inspection and
into operation.
•
A
wiring must conform to standard wiring practice in accordance with national and local wiring codes.
•
Door
must swing freely through the entire opening and closing cycle before beginning of installation.
•
Incorrectly
installed or improperly adjusted door operators can cause property damage or personal
injury.
•
A
dimensions are given in inches (millimeters), unless otherwise note.
•
Before installation, verify door frame is properly reinforced and is well anchored in the wall.
•
Concealed electrical conduit and concealed switch or sensor wires should be pulled to the frame before
proceeding.
CAUTION
4.3 Electrical
lines
into the
the
clearly
its correct
control
to
the
operator to
these
a
installation.
is
the
the
to ease in the
process.
the
arm is
the
in the correct
moving parts
the
the
any
controls or accessories into the
any moving parts.
the motor is
is no resistance against the
opening
or
or arm
arm
close
close very
very
an electrical access hole is
the
