20
49-2000695 Rev. 0
OVEN DOORS
Lift-Off Oven Door
The door is very heavy. Be careful when removing and
lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame,
to the unlocked position. A tool, such as a small
flat-blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until
both hinge arms are clear
of the slots.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
3. Fully open the
door. If the door
will not fully open,
the indentation
is not seated
correctly in the
bottom edge of
the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
5. Close the oven door.
Removal position
Hinge lock
Slot
Pull hinge locks down to unlock
Push hinge locks up to lock
Hinge
lock
Hinge
arm
Indentation
Bottom
edge of slot
Hinge arm
OVEN LIGHT REPLACEMENT
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Remove oven racks.
3. Remove the screws holding the steel frame.
NOTE:
The glass and gasket will be loose and can fall
when all of the screws are removed.
4. Remove the glass light cover, gasket, and steel
frame..
5. Remove the bulb by firmly grasping and sliding the
bulb straight out until the two prongs have cleared the
ceramic holder.
6. Do not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when it
lights. Grasp the replacement bulb with a clean towel
or facial tissue with the prongs facing down. Align the
two prongs in the ceramic holder, pressing gently until
the bulb is securely in the ceramic socket.
7. Align the frame, gasket, and glass in a horizontal
position and rotate them into place on the oven wall,
taking care not to pinch the silicone gasket seal.
8. Re-insert the screws that were previously removed.
9. Reconnect power.
WARNING
SHOCK OR BURN HAZARD:
Before replacing oven light bulb, disconnect the electrical power to the
oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
CAUTION
BURN HAZARD:
The glass cover and bulb should be removed when cool. Touching hot glass
with bare hands or a damp cloth can cause burns.
CARE AND CLEANING
Care and Cleaning
Содержание CMB903M2NS5
