Caen RFID Hex R1290I, Техническое руководство

Страница: 37 / 57

CONFIGURATION USING THE WEB INTERFACE - Hex R1290I Technical Information Manual 37
5 EASY2READ PROFILE
Introduction
By default. the reader profile is set to easy2read. For details on the available profiles and on the activation method,
please refer to §
RFID paragraph page 19 (configuration via reader) or § RFID paragraph page 27 (configuration via web
interface).
With the easy2read profile active you will use the CAEN RFID easy2read communication protocol. Select this option in
order to control the reader using the CAEN RFID Easy Controller Application or the SDK (Software Development Kit)
library.
To configure the reader when using the easy2read profile please refer to the § Easy2Rd opt. paragraph page 19
(configuration via web interface), or to the § Easy2Rd opt. paragraph page 19 (configuration via reader).
Connecting to the Hex Reader using the Ethernet port
Ethernet Communication Setup
The Hex reader can be connected to a PC using an Ethernet cable. In order to correctly operate with the reader follow
the steps above:
1. Connect the Hex to the power supply, the power LED will turn on, wait about 25 seconds until you hear a beep,
wait 15 seconds again until the screen will inform you that the reader is ready to work with the
easy2read
profile active.
2. Plug an Ethernet cable (not provided) into your computer and connect the other end of the Ethernet cable to
the reader. By default, the Hex R1290I is configured with the static IP address 192.168.0.2. If your private
network matches the default network configuration of the reader you can connect to it. Otherwise you can
either change the network configuration of the reader (see §
NETWORK page 18) to connect it to your network
or disconnect your PC from your network and connect it to the network of the reader.
Now you can use the CAEN RFID Easy Controller Application to control the reader. For details refer to § Easy Controller
page 38.