14/23 www.cadis.be [email protected]
User’s Manual
Aquavision Control
Monitoring Module
Check whether the installation of pipelines and water meters matches the configuration made by the installer on
the module. Only the installed water meters can be shown as active in the screen. You can change the data, line
by line, by clicking on the pencil on the right.
If you click on the pencil
on the right, the next screen opens where you can amend the data per pipe:
The ID of the water meter and the name of the pipe can be filled in or changed here.
Check whether or not the water meter has been installed in the corresponding pipe and click to set it to Active
or Non-active (if a water meter has been installed on the street side, that too should be set to Active)
Adjust the total of the water meter index appropriately so that the values correspond.
