Black plate (36,1)
Cadillac Escalade Owner Manual (GMNA-Localizing-Europe-7132796) -
2014 - CRC - 7/12/13
5-36
Instruments and Controls
MANUAL SHIFT
This message displays when the
automatic transmission is in manual
mode. See
Manual Mode on
page 9-27
for more information.
TRANSMISSION HOT IDLE
ENGINE
Notice:
Do not drive the vehicle
while the transmission fluid is
overheating and the transmission
temperature warning is displayed
on the instrument cluster and/or
DIC, or the transmission can be
damaged. This could lead to
costly repairs that would not be
covered by the warranty.
This message displays along with
four chimes if the transmission fluid
in the vehicle gets hot. Driving with
the transmission fluid temperature
high can cause damage to the
vehicle. Stop the vehicle and let it
idle to allow the transmission to
cool. This message clears and the
chime stops when the fluid
temperature reaches a safe level.
Vehicle Reminder
Messages
ICE POSSIBLE DRIVE
WITH CARE
This message displays when ice
conditions are possible.
Washer Fluid Messages
WASHER FLUID LOW ADD
FLUID
This message displays when the
windscreen washer fluid is low. Fill
the windscreen washer fluid
reservoir as soon as possible. See
Engine Compartment Overview on
page 10-5
for the location of the
windscreen washer fluid reservoir.
Also, see
Washer Fluid on
page 10-20
for more information.
Vehicle
Personalisation
Your vehicle may have
customisation capabilities that allow
you to program certain features to
one preferred setting. Customisation
features can only be programmed to
one setting on the vehicle and
cannot be programmed to a
preferred setting for two different
drivers.
All of the customisation options may
not be available on your vehicle.
Only the options available will be
displayed on the DIC.
The default settings for the
customisation features were set
when your vehicle left the factory,
but may have been changed from
their default state since then.
The customisation preferences are
automatically recalled.
To change customisation
preferences, use the following
procedure.