CADDX xGenConnect, Инструкция по установке и программированию

Страница: 45 / 166

xGenConnect Installation and Programming Guide 33
Arming and Disarming Your System
You may arm and disarm partitions from an NXG-18xx keypad.
Only users with an authorized user code (Level 2 user) will be allowed to use the
xGenConnect alarm system. Users with no valid user code (Level 1 user) do not
have access as defined by EN 50131-3.
Keypress Tamper
The NXG-18xx keypad will be locked in screensaver mode when unused for
a preset time. This stops unauthorized users from interacting with the system or
viewing detailed status.
A valid PIN is required to unlock the screen and access the system. Users can
set PIN codes between 4 and 8 digits in length.
Note: EN 50131 Grade 2 required settings
– there are no disallowed account
codes. 5 digits minimum to provide 10,000 possible combinations.
Lock Out on 3 Invalid PIN Attempts
If an invalid PIN code is entered three times, the keypad will deny all login
attempts for 90 seconds. Attempts are counted from any method (e.g. keypad,
app, or web page). You must wait the full 90 seconds before trying again with the
correct PIN. This is to prevent brute-force attacks on guessing PIN codes.
Lock Out on 10 Invalid Card Attempts
If an invalid card or tag is presented to the NXG-1832 / NXG-1833-EUR keypad
10 times, the keypad will ignore further attempts to read the card for the next
90 seconds. The card or tag may not be compatible with the system, not have
been secured or added to a user, or the user card or tag may have been
disabled.
Arm Your System with NXG-1820-EUR keypad
Arm Your System in Away Mode
Enter a valid PIN code to unlock the screen.
Touch the Away or Away + button to arm your system in Away mode.
The icon will change to red when the alarm system is set in away mode.
If your system has multi-partition control enabled, the Away + button will be
displayed.