APP-VI
B-Type
Revision B2005-2
1RQ
0
)DWDO
#
6WDUW
0
XS
#
(YHQWV
Sometimes an error is found during the start-up procedure which can be corrected
by the software, but it is still reported to the User for information. The message will
stay on the display for 1 to 2 seconds and then clear automatically. The same mes-
sage is recorded in the error log.
%DG
#
3DJH
#
1DPH
#
Q
%DG
#
3DJH
#
1R
1#
Q
There are 10 local memories and several other “pages” of information in the battery
backed memory. If any are found to be corrupt then a report is raised where n is the
relevant page number from 0 to F (hexadecimal).
7UDQVLHQW
#
HYHQWV
These errors will display a message on the CCM display, which may stop the opera-
tor for 1 or 2 seconds, because some piece of data was found to be corrupt. This will
most likely mean that a Cue was not performed as intended. The system will con-
tinue operating after the error message has been displayed.
(UURU
#
TXHXH
#
IXOO
The CCM has tried to add an error report to the Error log but it is full. There is space
sufficient for 1000 reports in the error log, but it is possible for this to fill up over the
life of a product. If this error occurs the user should empty the Error Log and refer to
the User Manual for instructions.
0,',
#
$
#
RYHUIORZ
0,',
#
%
#
RYHUIORZ
New MIDI data has been received from the automation system, but since the output
buffer for the MIDI Port is already full, the data cannot be queued and is therefore
lost. This error sometimes occurs when scanning through a list of Cues very quickly.
0,',
#
LQ
#
RYHUIORZ
New MIDI messages are being received quicker than the CCM can handle them as
the queue is full. The message will be lost.
0,',
#
,54
#
2YHUUXQ
0,',
#
,54
#
3DULW\
0,',
#
,54
#
)UDPLQJ
An error receiving MIDI data at the interrupt level. This is the lowest of data handling
and is probably indicative of cabling problems or electrical interference.
%DG
#
0,',
#
SRUW
New MIDI data has been received from the automation system but MIDI port speci-
fied is not recognized. This error would perhaps be indicative of poor quality commu-
nications cables or electrical interference.
0,',
#
EXIIHU
#
HU;
A number of errors with the MIDI buffers are reported as follows:
0,',
#
EXIIHU
#
HUU
4
Incorrect Type byte in MIDI Block Message
0,',
#
EXIIHU
#
HUU
5
Unrecognized destination in MIDI Block Message
0,',6HT
#
2YHUIORZ
The input buffer has been completely filled while recording a MIDI sequence. The
recording must stop.
The following message can occur when using the older serial RS232 communica-
tions:
7;
#
%XII
#
2YHUIORZ
%DG
#
/RFDO
#
5HVHQG
1R
#
UHSO\
#
IURP
#
3&
7;
#
%XIIHU
#
)XOO
%UHDN
#
UHFHLYHG
Содержание B-Type
