Cabletron Systems SSR-ATM29-02, Руководство пользователя, Страница: 131 / 386

CoreWatch User’s Guide 131
Chapter 9: Configuring Unicast Routing on the SSR
Note:
Setting both the RIP Packet Receipt and RIP Packet Transmission options to
Disabled will disable IP RIP on an interface. You may want to do so to
temporarily disable RIP on an interface.
8. Click OK.
9. Repeat step 5 through step 8 until you configure all the IP RIP interfaces necessary for
your network.
RIP Packet Transmission Specify whether the interface can send RIP updates. Select
Enabled if you want to send RIP updates from the
interface. Otherwise, select Disabled.
The setting of this option does not affect the sending of
updates to source gateways.
RIP Protocol Version Select which version of RIP is used on the interface.
Interface Type Specify whether the interface sends RIP updates as
multicast or broadcast messages by selecting the
appropriate option. The default is multicast.
You can set the interface type only if you select Version 2
for the RIP Protocol Version option.
Selecting broadcast specifies that RIP v1-compatible
RIP v2 packets must be broadcast on the specified
interface.
Incoming Route Metric Enter a number from 1 to 16 to specify a metric the
interface adds to incoming RIP routes before adding them
to the route table.
The default is the kernel interface metric plus 1 (the
default RIP hop count). If this value is specified, it will be
used as the absolute value and the kernel metric will not
be used.
Use this option to make the SSR prefer RIP routes learned
from this interface less than RIP routes from other
interfaces.
Outgoing Route Metric Enter the metric to be added to routes that are sent via this
interface. The default is 0.
This option is used to make other routers prefer other
sources of RIP routes over the SSR.
Table 15. RIP Parameters (Continued)
Parameter Description