Cabletron Systems SSR-ATM29-02, Руководство пользователя, Страница: 128 / 386

Chapter 9: Configuring Unicast Routing on the SSR
128 CoreWatch User’s Guide
3. Double-click the IP Routing Configuration object.
4. Double-click the IP Unicast Routing object. Then double-click the RIP Routing object
and click the RIP Global Parameters object.
A RIP Global Parameters dialog box similar to the following appears:
Figure 68. RIP Global Parameters Dialog Box
5. Specify whether you want to enable or disable RIP by selecting the appropriate
option.
By default, RIP is disabled on the SSR.
6. Leave the preference value set to its default (100) unless you want to assign a different
preference for the routes learned by RIP. To set the preference, enter a number from 0
to 255 in the Default Route Preference box.
The preference you specify applies to all IP RIP interfaces on the SSR.
Note:
Do not change the default preference value for RIP routes unless you fully
understand the implications of doing so.
As discussed in “What Is Preference?” on page 126 , you can set preferences in several
places. The SSR uses preference values to determine the preference of routes from one
protocol or peer over another. However, if a CLI command was used to set a preference
in an import routing policy, that preference overrides the one you specify on the RIP
Global Parameters dialog box.
7. Set the metric for routes advertised through RIP by entering a number from 1 to 16 in
the Default Metric box.