INSTALLING THE ETWMIM
Page 3-6
3.
Slide the EPIM into place, making sure the connectors on the rear
of the module and inside the ETWMIM attach properly.
4.
Tighten the EPIM mounting screw.
Figure 3-3. EPIM Replacement
Note: See Appendix A for EPIM specifications and cabling information.
3.5
INSTALLING THE T1-SRM
The ETWMIM allows for an optional T1-SRM. To install this optional
T1 interface you need the following tools:
•
disposable static wrist strap (provided with your ETWMIM)
•
5/16” nut driver, or equivalent.
After obtaining the necessary equipment, refer to Figure 3-4 and
proceed as follows:
1.
Using the nut driver, remove the T1 cover plate lock-nuts from the
inside of the ETWMIM faceplate.
2.
Remove the T1 cover plate and save it in the event you want to
remove the T1-SRM at a later date.
3.
Remove the T1-SRM from its protective package.
4.
Attach the T1-SRM such that the holes on the ends of the device
slide over the bolts on the back of the ETWMIM faceplate. (See
Figure 3-4.)
Mounting Screw
