Page 3-1
CHAPTER 3
INSTALLING THE ETWMIM
This section contains instructions for installing the ETWMIM. Verify
that all network design guidelines and site requirements listed in
Chapter 2, Installation Requirements/Specifications, are met
before installing the ETWMIM.
3.1
UNPACKING THE ETWMIM
Before installing the ETWMIM, visually inspect the unit and check
the contents of your shipping box with the list below.
•
ETWMIM (1)
•
set of release notes (1)
•
disposable wrist strap (1)
•
ETWMIM User’s Guide
•
cable connection kit (1)
Warning: Electrostatic Discharge (ESD) can damage the ETWMIM.
Observe all precautions to prevent electrostatic discharges when
handling the ETWMIM. These precautions include wearing the
disposable wrist strap included in your shipping package, holding only
the edges of the board or the metal front panel, and not touching the
components or surface of the board.
To unpack the unit:
1) Carefully remove the ETWMIM from the shipping box.
2.) Remove the ETWMIM from the protective plastic bag.
Note: If you must set the ETWMIM down for any reason, place it back
inside the protective bag. This will help prevent ESD damage.
Contact Cabletron Systems Technical Support immediately if you
encounter any problems unpacking or installing the ETWMIM.
