Model 512 Instruction Manual
Page 65
>
>
ED
EDIT (W, U)
EDIT Wire List
W 0001
I
Initialize? Y
W 0001
R
W
RW 0001
NOTE
Two lines are displayed while in the Replace mode each time a
new circuit or wire is entered. The first line, with only a W to the
left, is the data already entered for that sequence (line). With no
data entered, the line will be blank as shown above.
6. The wire list document for the wire harness will be used for entering the From/To list.
Enter P3-4, the first termination point in the Wire List and press ENTER.
NOTE
For build applications, the line order of the From/To list
determines the sequential build order. The list should be entered
in the proper order for the application.
7. Type P1-A, the To point termination of the first circuit in the wire list, and press ENTER.
8. The third column is for the wire or circuit label; it can contain information regarding the
circuit or wire up to 12 characters. For this example, the wire number will be used for
added information. For other applications, the wire color and gauge may be used. Type
WS01, and press ENTER.
9. Type the From point, P3-2, for the second wire, and press ENTER.
10. Type the To point, P1-B, for the second wire, and press ENTER.
11. Type WS02, the wire label for circuit 2, and press ENTER.
Содержание 512
