C2R 30-005, Руководство пользователя

Страница: 49 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved
49
Rev. A
LED Power Level
This selection allows you to adjust LED and aimer brightness.
Off is used when no
illumination is needed. Low is used if low illumination is sufficient. High the default is the
brightest setting.
If you have an aimer delay programmed (see Aimer Delay), the aimer will be at 100% power
during the delay, regardless of the LED Power Level.
Note:
If you scan the Off bar code, both the aimer and illumination lights turn off, making it
difficult to scan bar codes in low light. To turn the LED Power Level back on, move to a
brightly lit area and scan either the
Low or the High bar code below.
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On bar code,
below. However, if you want to turn just the lights off, scan the Lights Off bar code.
Note: This setting does not affect the aimer light. The aiming light can be set using Aimer
Modes.
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle for the specified time.
To prevent the imager from powering down, set this time-out to 0. Scan the bar code below,
then set the time-out by scanning digits (from 0 - 999,999 ms) from the inside back cover, then