C2R 30-005, Руководство пользователя

Страница: 42 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved.
42 42
Rev. A
Number of Beeps
– Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of
beeps will be applied to the beeper and LED in response to a good read. For example, if you
program this option to have five beeps, there will be five beeps and five LED flashes in
response to a good read. The beeps and LED flashes are in sync with one another. To change
the number of beeps, scan the bar code below and then scan a digit (1-9) bar code and the
Save bar code on the Programming Chart inside the back
Default = 1.
Number of Beeps
– Error
The number of beeps and LED flashes emitted by the scanner for a badread or error can be
programmed from 1 - 9. For example, if you program this option to have five error beeps,
there will be five error beeps and five LED flashes in response to an error. To change the
number of error beeps, scan the bar code below and then scan a digit (1-9) bar code and the
Save bar code on the Programming Chart inside the back cover of this manual.
Default = 1.
Beep Polarity
Beep Polarity sets the idle and active states of the beeper signal. When set to
Active High ,
the beeper sounds when the signal shifts from low to high. When set to Active Low , the
beeper sounds when the signal shifts from high to low.
If the beeper is enabled for a good read (see Beeper
– Good Read),the polarity change takes
effect after the next successful decode or a power cycle. If the beeper is disabled, a polarity
change only takes effect after a power cycle. Default = Active Low.
Note: Beep Polarity sets the beeper signal voltage level to either high (Active Low) or low
(Active High). This will affect Beeper-Good Read settings. If the beeper has been disabled,
make sure it is not turned on accidentally by a polarity change.
Good Read Delay