C2R 30-005, Руководство пользователя

Страница: 44 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved.
44 44
Rev. A
Serial Trigger
You can activate the scanner either by pressing the trigger, or using a serial trigger command
(see
Trigger Commands ). When in serial mode, the scanner scans until a bar code has been
read or until the deactivate command is sent. The scanner can also be set to turn itself off after
a specified time has elapsed (see
Read Time-Out , which follows).
Read Time-Out
Use this selection to set a time-
out (in milliseconds) of the imager’s trigger when using serial
commands to trigger the imager, or if the imager is in manual trigger mode. Once the imager
has timed out, you can activate the imager either by pressing the trigger or using a serial
trigger command. After scanning the Read Time-Out bar code, set the time-out duration (from
0-300,000 milliseconds) by scanning digits from the inside back cover, then scanning Save.
Default = 30 000 ms.
Manual Trigger, Low Power
Note: For RS-232 mode only.
The imager powers down until the trigger is pulled. When the trigger is pulled, the imager
powers up and operates until there is no triggering for the time set with the
Low Power Time-
Out bar code below. There is a delay of up to one second in operation when the imager is first
triggered, but there is no delay when operating in low power time-out mode.
Low Power Time-Out Timer
Note: For RS-232 mode only.
Scan the Low Power Time-Out bar code to change the time-out duration (in seconds). Then