C2R 30-005, Руководство пользователя

Страница: 45 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved
45
Rev. A
scan the time-out duration (from 0-300 seconds) from the inside back cover, and Save. Default
= 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into low power
mode. Whenever the trigger is enabled, the low power time-out timer is reset.
Note: This time-out does not begin until the imager time-out setting has expired.
Presentation Mode
This programs the imager to work in Presentation mode. The LEDs are either off or at the
lowest power for ambient conditions until a bar code is presented to the imager. Then the
LEDs turn on automatically to read the code. Presentation Mode uses ambient light to detect
the bar codes. If the light level in the room is not high enough, Presentation Mode may not
work properly.
Presentation LED Behavior after Decode
When an imager is in presentation mode, the LEDs remain on and continue scanning for a
short time after a bar code is decoded. If you wish to turn the LEDs off immediately after a bar
code is decoded, scan the LEDs Off bar code, below. (If you want the LEDs to remain off for a
length of time after the decode, use Presentation LED Time-Out, below.) Default = LEDs On.
Presentation LED Time-Out
When using Presentation LED Behavior after Decode (above), you may want to set the time
the LEDs remain off after a decode. To set the duration of this delay, scan the bar code below,
then set the time-out by scanning digits (0 - 9,999 ms) from the Programming Chart on the
inside the back cover of this manual, then scanning
Save. Once the unit has completed this
time-out, it will immediately resume scanning.