C2R 30-005, Руководство пользователя

Страница: 50 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved.
50 50
Rev. A
scanning Save. Default = 1 ms.
Aimer Delay
The aimer delay allows a delay time for the operator to aim the imager before the picture is
taken. Use these codes to set the time between when the trigger is activated and when the
picture is taken. During the delay time, the aiming light
will appear, but the LEDs won’t turn on
until the delay time is over.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then
set the time-out by scanning digits (0 - 4,000 ms) from the Programming Chart inside the back
cover of this manual, then scan
Save .
Aimer Modes
Interlaced
In interlaced mode, the illumination and aiming timing is automatically synchronized to the
imager exposure period by the Image Engine. The engine turns illumination on while the image
is being exposed, and it turns the aiming off at all other times. The interlaced mode provides
the lowest overall current draw and is recommended for most applications. It also provides the
brightest aimer in most applications. The Image Engine software automatically maintains an
approximate 25% aimer duty cycle, even when the imager exposure time is at its maximum in
dark operating environments.
Select Off if you don’t want to use either aimer mode