- 20 -
You can also print the test results in the [Print] interface.
6. After the test is completed, the pressure machine will return to the initial position at the set rate.
7. After the test is completed, turn off the power and cut off the power supply of the equipment.
8. After the test is completed, wipe and clean the tooling and instrument in time to keep the
instrument clean.
VII.
Maintenance and precautions
Maintenance
Keep the equipment clean and tidy, and dust cloth should be covered when it is not used for a
long time.
After use, clean and wipe the equipment in time.
After the device is placed for a period of time, it is necessary to clean up the dust, and check
whether the motor is working properly after turning on the device.
The reducer is lubricated with grease. Add special reducer grease 2#. Refuel once a week, with
400-500g refueling.
Precautions
Pay attention to safety when using it to prevent your hands from being caught.
When troubleshooting, be sure to cut off the power supply.
The equipment shell must be reliably grounded to ensure safe operation.
WARNING!
When the equipment fails, the power supply should be cut off immediately. It
can be used after being overhauled by professionals!
VIII.
Packing, storage and transportation
Содержание HTHY-0709
Страница 1: ...I MARSHALL STABILITY TESTER HTHY 0709 0710...
Страница 10: ...8 Diagram 1 Diagram 2...
Страница 11: ...9 Circuit diagram 3 Figure 4 2 Wiring diagram of the circuit part...
Страница 26: ...24...